SmartPool DIRECT COMMAND Manual De Funcionamiento página 3

INSTALLATION
DO NOT RUN THE CLEANER OUT OF THE WATER.
OPERATING THE CLEANER OUT OF THE WATER WILL DAMAGE THE MOTORS AND VOID THE WARRANTY
IMPORTANT NOTE: During normal operation, the cleaner will appear to shut off for a few seconds. This is normal and part of the
pool cleaning program. The unit has multiple ways of cleaning the walls. It may climb to the top, scrub, then make a turn and drive
back down the wall to the bottom of the pool. It may also climb to the top, shut down for a few seconds, remove itself from the
wall, turn its pump motor on again, pushing itself down to the bottom of the pool away from the wall. It could also climb the wall,
scrub the waterline, turn its pump motor off, and float away from the wall down to the bottom. All of these variations have been
programmed into the cleaner and are designed to most quickly and efficiently clean your entire pool.
This unit has been designed to clean all areas of your pool. It will climb the walls, and occasionally break the surface. In the process
of climbing the wall it may stay on the surface and continue to operate from several seconds to a few minutes. This is normal
operation procedure and the cleaner will eventually make its way to the bottom to continue its cleaning. Since most of the dirt is
concentrated on the floor of the pool, the cleaner will spend the majority of its time on the floor.
REMOTE CONTROL OPERATION:
DO NOT HOLD THE BUTTON DOWN, AS THE VACUUM WILL TRAVEL IN THE DESIRED
DIRECTION UNTIL THE RED STOP BUTTON IS PUSHED.