Ingersoll Rand POWERFORCE PF220 Instrucciones página 2

To avoid accidental starting - - ensure tool is in "off"
•
position before applying air pressure, avoid trigger
when carrying, and release trigger with loss of air.
Never leave equipment unattended. Keep away from
•
children or anyone not familiar with the operation of
the spray gun.
Read product labels and Material Safety Data Sheets
•
(MSDS) before using paint and solvents.
Repetitive motions or uncomfortable positions may be
•
harmful to your hands and arms. Stop using any tool
if discomfort, tingling feeling or pain occurs. Seek
medical advice before resuming use.
Feed
Siphon
Spray Gun Handling
Do not point the spray gun at anyone or at any part of
the body.
Ensure appropriate air line filter is being used. Water,
oil, and debris in the air may cause damage to the
workpiece.
The spray gun should be held perpendicular to the work
surface and 6 to 12 inches from the work surface.
Keep the gun parallel to the work surface during the stroke
to ensure even coating. DO NOT move the gun in an arc.
This will result in a build up of paint in the center of the
stroke and a light coating at each end.
Start the gun moving prior to pulling the trigger and release
the trigger before stopping the gun movement.
Overlap strokes enough to get a uniform finish.
Using the Tool (Continued)
SPECIFICATIONS
Maximum Air Pressure
70 psig
Main Line(s) Inner Ø
to be 3X Size of
Air Tool's Inlet Ø
To Air
System
To Air
Tool
R
Emergency
Shut--Off
Valve
Regulator
Drain Regularly
OPERATIONS
Dispose of hazardous fluid according to all local,
•
state, and national guidelines. Store hazardous fluid in
an approved container.
Do not carry or drag the tool by the hose.
•
Wear the correct respirator. Consult MSDS of
•
material being used for respiratory protection.
Do not spray non- -recommended materials such as
•
acids, corrosive materials, toxic chemicals, fertilizers
or pesticides.
Keep body stance balanced and firm. Do not
•
overreach when operating this tool.
Branch Line(s) Inner Ø
to be 2X Size of
Air Tool's Inlet Ø
F
Filter
Compressor
(Dwg. TPD905- -2a)
2
Inlet Thread
1/4" NPS
(Dwg. TP2043)