Ingersoll Rand POWERFORCE PF220 Instrucciones página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fan DIrection
Always turn off the air supply and disconnect the air
supply hose before installing, removing or adjusting
any accessory on this tool, or before performing any
maintenance on this tool.
The direction of the fan can be adjusted from horizontal to
vertical be loosening the lock ring and turning the air cap
to the proper location. Hand tighten lock ring after
adjustment.
Dispose of hazardous fluid according to all local, state,
and national guidelines.
Always turn off the air supply and disconnect the air
supply hose before installing, removing or adjusting
any accessory on this tool, or before performing any
maintenance on this tool.
Clean spray gun and canisters immediately after use.
Paint or other fluids can dry quickly and can easily plug
internal passageways and render the spray gun useless.
Do not use Methylene chloride (Dichloromethane) or
any halogenated hydrocarbon solvents with this spray
gun.
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Operations (Continued)
(Dwg. TP2053)
(Dwg. TP2044)
Figure 1
SAVE THESE INSTRUCTIONS. DO NOT DESTROY.
The pattern control knob (Figure 1) adjusts the size of the
fan. A wide fan will result if the knob is fully opened by
turning it counterclockwise. As the knob is turned
clockwise, a smaller round pattern will be achieved.
The fluid control knob (Figure 1) will adjust the
atomization of the paint. Turn the knob clockwise until
fully closed. Then while turning the knob
counterclockwise, trigger short bursts of paint. This
counterclockwise movement of the knob will move the
pattern from fine to coarse. Adjust the knob until the
desired pattern is obtained.
If the pattern is too coarse and the fluid control knob can
not adjust it properly, try adjusting the air pressure or thin
the paint to achieve desired pattern.
MAINTENANCE
Remove and empty the canister. Rinse canister with a
solvent recommended for the paint being used.
Fill canister with solvent and attach to spray gun. Spray
solvent into an approved container, while shaking the gun
vigorously. Continue until all traces of paint have been
eliminated from spray. Also wipe the exterior of the gun
with a rag soaked with the solvent.
Remove the air cap and soak in solvent. Use a toothpick
or plastic brush, to clean air passages.
Using metal objects can damage the precision air
passages. DO NOT soak spray gun in solvent. This can
damage non- - metallic components.
After cleaning, lubricate lightly in the areas shown in
the exploded view with NON- - SILICONE OIL.
Silicone oil can cause oil spots to occur in the paint.
3
Pattern Control
(Dwg. TP2045)
Fluid Control

Publicidad

Tabla de contenido
loading

Tabla de contenido