Publicidad
SLIDING DOOR HARDWARE - BY PASS
BYP-103 & BYP-153 Series / BYP-102 & BYP-152 Series
1
PREPARE OPENING
Hmax = Door Height + A • Hmin = Door Height + B
A
Side Mount
2-17/32
2-5/32
Top Mount
3
2-3/8
2-Door Width = 2 x Door Width - 1"
2
MOUNT FRAME HARDWARE
• Center tracks in opening.
• Using track as template, mark screw
locations.
• Drill 3/32" pilot holes and secure with
(# 10 x 1-1/2") screws (not included).
• Place carriers on track at cutout
with quick release slots facing out.
• Place door bumpers on track to
prevent carriers from rolling off track.
Note: If necessary, track may be cut
with a fine tooth saw.
3
MOUNT DOOR HARDWARE
Top Mount Plate
• Place door mount plate centered on top of each
door at the distance shown from the outside edge.
• Using plates as a template, drill 3/32" diameter
holes for mounting and one 3/8" clearance hole
5/8" deep for adjustment screw and secure with
(#8 x 1") screws.
• Mount pulls (not included).
Side Mount Plate
• Place door mount plate on the side of each door at
the distance shown from the outside edge.
Important: Mount plates with both screws at top
right of both slots with top of bracket flush with
door to allow for adjustment.
• Using plates as a template, drill 3/32" diameter
holes and secure with (#8 x 3/4") screws.
• Mount pulls (not included).
B
Opening Width
Largeur d'ouverture
Anchura de la abertura
#N310518_A (0116)
Opening Height
Hauteur Ouverture
Altura Abertura
Length
48"
60"
72"
96"
120"
144"
192"
2-1/2"
(6,4 cm)
3/4"
(1,9 cm)
2-1/2"
(6,4 cm)
3/4"
(1,9 cm)
DOOR MOUNTING HARDWARE
Track
Door Thickness
Top Mounting Plate
3/4"
Centered
Narrow
1-1/8"
NA
1-3/8"
NA
Wide
1-3/4"
Centered
Assembly
Instructions
Side Mount Plate
1-25/32" – 2-1/32"
Top Mount Plate
2" – 2-1/2"
Door Height
Hauteur Porte
Altura Puerta
3/8" -1/2"
No. of Screws
5
6
7
9
11
13
17
Side Mounting Plates
Front Door
Back Door
1934
1934
1934
1938
1938
1938
1934
1938
Publicidad
