Operating Your Coffee Maker - DeLonghi DC51TT Serie Manual De Instrucciones

OPERATING YOUR COFFEE MAKER

PREPARING COFFEE MAKER FOR BREWING COFFEE:
1. Place the coffee maker on a flat, level surface away from
any edge.
2. Plug the unit into a 120V / 60Hz only outlet.
3. The lid of the carafe must be fitted properly during the
brewing process. And the carafe must be set on the non-
stick plate.
FILLING THE WATER RESERVOIR: Figure 2
4. Open the hinged water reservoir cover located at
the top of the coffee maker.
5. Fill the carafe with cold water corresponding to the
desired cups of coffee you will be brewing. Cup
markings are indicated on the handle of the carafe.
6. Empty the water from the carafe into the water
reservoir, located behind the filter basket holder. NOTE:
The automatic brewing system has been designed to
work with cold water only.
NOTE: The amount of brewed coffee after the brewing process is complete will
always be slightly less than the amount of water placed in the coffee maker's water
reservoir, since some water is absorbed by the coffee grounds and filter. Add a
little extra water at the beginning so that you have the exact number of cups
desired.
PREPARING THE COFFEE:
7. Insert a #4 cone-shaped filter into the filter basket before filling with coffee
grounds. Place the filter into the removable filter basket. Place the desired
amount of coffee grounds into the filter. NOTE: We recommend using coffee
grounds specifically for automatic drip coffee makers. We suggest one
tablespoon of ground coffee for each cup of coffee being brewed. After
using your drip coffee maker a few times you may adjust the amount to suit
your own taste.
8. Return the filter basket with the coffee-filled filter to the filter basket holder. Be
sure that the filter basket is seated properly in the filter basket holder.
9. Close the hinged water reservoir cover. Place the carafe with the lid in place
on the non-stick plate.
FIGURE 2
-6-