Lenco LBT-188 Manual De Usuario página 12

Operation
Turntable Operation
1. Connect the included power adapter to unit and press the power
rocker switch to be "ON" position.
2. Remove the needle cover from the cartridge.
3. Place the slipmat on the platter and place a record on the slipmat. If
using 45 RPM records, put the 45 RPM adapter on the center spindle
before placing the record on the platter.
4. Set the 33/45 RPM Selector according to the type of record.
5. Turn the Start/Stop dial to the Start position to begin spinning the
platter.
6. Unlock the arm clip and set the Lift Lever to the up position.
7. Position the tonearm over the desired location (groove) on the record.
8. Move the tonearm lift lever to the down position to move the tonearm
toward the record. Alternatively, place the needle over the desired
location on the record.
9. Carefully lower the tonearm on the record.
10. When you are finished playing the record, raise the tonearm, return it
to rest on the arm clip, and turn the Start/Stop dial to the Stop.
Bluetooth Operation
This unit has a Bluetooth transmitter to send audio to a Bluetooth speaker
wirelessly.
1. Power on your Bluetooth speaker and ensure it is in pairing mode.
2. Power on the unit, the BT will auto search when the unit turn on, the
BT indicated light flashing.
3. When pairing, the light will flash twice per second, then change to be
long lighting when paired;
Note: This unit will connect to the closest Bluetooth speaker that is
near it. If after 2 minutes no Bluetooth speaker can be found to pair
11