DeWalt D25012 Manual De Instrucciones página 9

To reverse the rotary hammer, turn it off and align the reversing lever
(H) with the yellow arrow pointing backward (viewed when holding drill
in operating position).
To position the lever for forward operation, turn the rotary hammer off
and align the reversing lever (H) with the yellow arrow pointing forward
(viewed when holding drill in operating position).
Mode Selector (Fig. 3)
NOTICE: Tool must come to a complete stop before activating the
mode selector button or damage to the tool may result.
FIG. 3
D25012
HAMMERDRILL
MODE
HAMMER-
ONLY
MODE
F
G
DRILL-ONLY
MODE
F
G
F
G
DRILL-ONLY MODE
To use drill-only mode, press mode selector button (F) and turn the
mode selector (G) so the yellow arrow points to the corresponding
symbol as shown. Use drill-only mode for wood, metal, and plastics.
HAMMERDRILL MODE
To use hammerdrill mode, press the mode selector button (F) and turn
the mode selector (G) so the yellow arrow points to the corresponding
symbol as shown. Use this mode for masonry drilling.
HAMMER-ONLY MODE
(D25013, D25023)
For light chiseling, press the mode selector button (F) and turn the
mode selector (G) so the yellow arrow points to the corresponding
symbol as shown.
NOTE: The yellow arrow on the mode selector MUST be aligned
with one of the symbols at all times. There are no operable positions
between the positions.
®
SDS Plus Chuck (Fig. 1)
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories.
WARNING: Burn Hazard. ALWAYS wear gloves when changing
bits. Accessible metal parts on the tool and bits may get extremely
hot during operation. Small bits of broken material may damage bare
hands.
WARNING: Do not attempt to tighten or loosen drill bits (or any
other accessory) by gripping the front part of the chuck and turning
the tool on. Damage to the chuck and personal injury may occur.
7