Blade Assembly; Light Kit Assembly. Pgs - Litex Industries BRC52AB5C Guia De Instalacion

9. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware pack. Hold blade arm up
to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with Phillips screwdriver. Repeat procedure for
the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (save blade arm screws and
lock washers to secure blade arms). Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. [Important: When installing blade arm,
place a long fiber washer (provided in a
hardware pack) between motor and blade arm
to reduce vibration of metal to metal surfaces.]
Before securing screws permanently, repeat
procedure with remaining blade arms.
Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
10. Light Kit Assembly (Optional).
If you wish to use your fan WITH the light kit,
please follow instructions starting on the
following page.
If you wish to use your fan WITHOUT the light
kit, remove 3 screws from switch housing cap.
Align holes in switch housing cap with holes in
switch housing. Attach switch housing cap to
switch housing with screws that were just
removed. Securely tighten all screws. Please
proceed to Section 11 on the following page to
complete installation WITHOUT the light kit.
["Light Kit Assembly" continued on next
page.]
plastic
motor
lock
fiber washer
lock washers
switch
housing
page 6
motor housing
blade attachment
screws and washers
blade arm
blade arm screws
motor housing
switch housing cap
blade