RISCO Group EL-5803 Instrucciones De Instalación página 12

EN
TESTING YOUR SMOKE AND HEAT DETECTOR
To be sure the detector is working
correctly, test the detector at initial
installation, and then test weekly
by performing the following
procedure:
1. Use your finger to firmly
press the test button. If the
detector is functioning
correctly, the alarm horn
sounds and an alarm
message is sent to the
panel.
2. To stop the alarm horn,
press the test button again.
If the detector fails to test properly, have it repaired or replaced immediately.
If the alarm horn begins to beep once every 35 seconds, it means that the detector's batteries
are weak. Replace the batteries immediately. Keep fresh batteries on hand for this purpose.
NOTES:
1. If you wish to perform a spray test, the spray must be at a distance of 20 cm away from the
detector. Press on the spray continuously for at least 5 seconds; the LED will flash every
second for 25 seconds followed by alarm activation.
2. Cooking smoke or a dusty furnace (sometimes called "friendly fires"
to sound. If this happens, open a window or fan the air to remove the smoke or dust. The
alarm will turn off as soon as the air is completely clear. If, however, the smoke alarm
continues, activate the heat-only mode. Do not disconnect the batteries from the detector.
This will cancel your protection from fire.
12 1 & 2-Way Smoke & Heat Detector
Figure 9: Smoke and heat detector Cover
)
can cause the alarm