Harbor Breeze CALERA Manual Del Usuario página 8

INITIAL INSTALLATION
4. Remove the two mounting bracket screws (HH)
from the round holes of canopy (B). Set aside
for later use. Detach mounting bracket (C) from
canopy (B), then attach mounting bracket (C) to
outlet box (not included) using screws and washers
provided with the outlet box.

Note: It is very important you use the proper
hardware when installing the mounting bracket
(C) as this will support the fan.

Important: If using the angle mount, ensure the open
end of the mounting bracket (C) is installed
facing the higher point of the ceiling.
Hardware Used
Mounting
HH
Bracket Screw
5. Remove and discard the three rubber stoppers and
five plastic spacers from the underside of the motor
housing assembly (E).
For Standard or Angle Mounting Instructions, continue
to page 9. For Closemount Instructions, proceed to
page 12.
4
B
x 2
5
Rubber
Stopper
8
C
C
Lowes.com/harborbreeze
HH
Plastic
Spacer
E