Harman Infinity Reference 3004A Manual De Propietario página 5

WIRING FOR OUTPUT
Reference 3004A 4-channel output (4ohm/2ohm)
+ -
Front left speaker
FRONT
L R
+ -
Front right speaker
Reference 3004A 3-channel output (Font: 4ohm/2ohm;
Rear:4ohm)
+ -
Front left speaker
FRONT REAR
L R L R
BRIDGED BRIDGED
+ -
Front right speaker
Reference 3004A 2-channel output (4ohm)
+ -
Subwoofer
FRONT REAR
L R L
BRIDGED BRIDGED
Reference 7005A 5-channel output (4ohm/2ohm)
+ - + -
Front left speaker Rear right speaker
FRONT REAR SUB
L R L R
BRIDGED BRIDGED
+ - + -
Front right speaker Rear left speaker
Reference 3004A and
Reference 7005A Amplifiers
+ -
Rear right speaker
REAR
L R
+ -
Rear left speaker
+ -
Subwoofer
R
+ -
Subwoofer
+ -
Subwoofer
CONNECTING THE REMOTE BASS
CONTROLLER (REFERENCE 7005A ONLY)
SETTING GAIN, CROSSOVERS, AND BASS
BOOST
Setting the gain
1. Start with
and the crossover control rotated midway.
2. For the front and rear channels, choose
music you're familiar with. For the
subwoofer channel on the Reference
MAX
7005A, choose music with substantial bass
GAIN
content.
MIN
3. Turn the volume control on your receiver to
¾ of its total output.
4. Adjust the
listening carefully to the bass output. If
you hear distortion, turn the
counterclockwise to decrease the gain.
Selecting the crossover mode
On the front and rear channels, you can select
your preferred crossover mode.
Choose to allow only frequencies
above a certain point to reach your speakers.
Recommended if you're using a subwoofer in
your system, as it keeps low base from your
full-range speakers.
HPF
Choose to allow only frequencies below
X-OVER
FULL
a certain point to reach your speakers.
LPF
Recommended if you're bridging the front or
rear channels to power a subwoofer.
Choose
your speakers. Recommended if you're not
using a subwoofer in your system.
Note: The crossover mode for the subwoofer
channel of the Reference 7005A is low-pass
only.
Selecting the crossover frequency
Choose the crossover point to suit listening
preferences. Turn the dials to the left to lower
320Hz
the crossover point and to the right to raise
FREQ
32Hz
the crossover point. Exact crossover settings
for coaxial speakers and subwoofers depend
on your listening preferences.
REMOTE
CONTROL
control set to minimum,
control clockwise,
control
to allow all frequencies to reach
EN