Product Safety Information; Accessory Installation - Ingersoll Rand 172 Serie Especificaciones Del Producto

Product Safety Information

Intended Use:
These Air Percussive Needle Scalers are designed for removal of unwanted deposits from metal
and other hardened materials through repetitive application of linear impacts of hardened nee-
dles or a tool steel that is retained and driven by the Scaler. Such deposits include weld spatter,
paint, coatings and other surface materials.
For additional information refer to Product Safety Information Manual Form 04581450.
Manuals can be downloaded from ingersollrandproducts.com.

Accessory Installation

● Always use appropriate retainer, latch or sleeve, in addition to proper barriers to protect
persons in surrounding or lower areas from possible ejected accessories.
●
Always turn off the air supply, bleed the air pressure and disconnect the air supply hose
when not in use, before installing, removing or adjusting any accessory on this tool, or
before performing any maintenance on this tool or any accessory.
● To install or remove a Chisel or other accessory, depress the Retainer Sleeve Lock
Plunger and rotate the Retainer Sleeve to the right as far as the slot in the Sleeve
permits. Install or remove the accessory and rotate the sleeve to the left until the Lock
Plunger snaps outward and locks the Sleeve against rotation in either direction.
Prior to Use
●
Do not lubricate tools with flammable or volatile liquids such as kerosene, diesel or jet
fuel. Use only recommended lubricants.
● Use only proper cleaning solvents to clean parts. Use only cleaning solvents which meet
current safety and health standards. Use cleaning solvents in a well ventilated area.
Tools are coated inside and out with rust-resisting oil before leaving the factory. Before using the
tool, remove this oil by dipping the tool in a suitable cleaning solution to wash the oil from the
exterior. Pour about 6 cm
tool for about 15 seconds. Dry the tool immediately after cleaning, pour 3 cm
No. 10 Oil into the air inlet and again operate the tool for 5 seconds to lubricate all working parts.
16574121_ed3
WARNING
WARNING
of a clean, suitable, cleaning solution into the air inlet and operate the
3
EN
of Ingersoll Rand
3
EN-1