ELTRA VOLANTE PAC-310 Manual Del Usuario página 22

4
PROGRAMMING MULTIPLE BUTTONS
A
B
C
NOTE :
You can programme up to a maximum of 4 buttons on one bell. If you attempt to programme a
fifth button, the bell will play an error signal.
5
RINGTONE CHOICE
B
TIP :
You can change the melody per bell for multiple buttons. Follow the instructions above per button.
BEEP Press the channel selection button at the back of the bell
for 3 seconds. The bell will produce a monotonous sound. It
is ready to read a second signal.
BEEP
Press the channel selection button at the side of the bell for
3 seconds. The bell will produce a monotonous sound. It is
ready to read a second signal.
♫ ♫
Within a minute, push the button. The bell will play a ring-
tone. This is now programmed on the button.
Leave it for 5 minutes before reusing it.
♫
To change a ringtone, do as follows:
• Open the button as in step 1A
• Press the "S" button. Your bell will play a new melody with
• The last selected melody will be remembered.
• You can choose between 8 different melodies.
•
each push.