Technical Data; Filter And Lubrication Requirements - Truper ENNE-160 Instructivo

Technical data

Recommended operation pressure
Maximum pressure allowed
Cartridge capacity
Air intake connection
Hose inner diameter
CAUTION
An increase in the pressure in the line or the inner diameter in the hose diameter shall be considered to
compensate the use of very long hoses (longer than 26.2 ft). The hose minimum inner diameter shall be 3/8" and the
connectors shall be ¼ NPT. Use good quality couplings and accessories with the right size.

Filter and lubrication requirements

CAUTION Dust, water and oil specific for using in pneumatic tools are the main cause of potential flaws with the tool. We
recommend installing a
lubrication reducing 80% oil consumption significantly increasing the air quality the operator breaths.
• The filter-oil feeder system must be regulated to administer 3 to 6 drops a minute.
• Drain the water in the air compressor tank and also condensation in the hoses before using the tool. Consult the air compressor
instructions.
Air
compressor
Code
Description
Staple gauge
Staple Crown
Staple length
Brand UNI-LL-1/4 centralized filter-oil feeder system. This system assures
UNI-LL-1/4
Centralized Filter-Oil
Feeder System
ENNE-160
13178
Pneumatic stapler
75 PSI- 110 PSI
110 PSI
100 staples
16
7/16"
3/4" to 2"
1/4 NPT
3/8"
Conector
Air Hose
3
ENGLISH