USING THE SPEAKERS
•
Press the ON / OFF button on your lamp or remote control. The light will turn on automatically.
•
Press the
button on your remote control to turn on Bluetooth. You will then hear a chime.
•
Turn on Bluetooth on your phone, computer, or tablet. The default Bluetooth name to enable is «SPEA-
KERLIGHTING». Click on the button to turn on your lamp, you will then hear a beep. Your device is ready
to be used.
•
You can manage music through your phone, computer, tablet or remote control.
•
If your device has already been connected to the lamp, it will automatically connect when you press the
button on your remote control.
•
If several devices were previously connected to the lamp, the last connected device will automatically
connect. For example, if you have previously connected phone A, then phone B, phone B will connect if
both phones try to connect at the same time.
•
When you want to connect another device to your Bluetooth speaker, go to the Bluetooth settings of the
device that is already connected, select the «SPEAKERLIGHTING» and «Disconnect» or «Unpair».
LED PATTERNS
BLUE: Bluetooth device is on and connected to the lamp, but music is not playing.
BLUE and blinking slowly: the Bluetooth is on and connected to the lamp, you have music playing.
BLUE and flashing quickly: the Bluetooth of your device is on but no device is connected to the lamp.
LED off: Bluetooth is switched off.
It is also possible to use the remote control :
Turns off / turns on Bluetooth
. . . . . .
Start / pause
. . . . . .
Go to the next song
. . . . . .
Return to the previous song
. . . . . .
Decrease sound volume
. . . . . .
Increase sound volume
. . . . . .
CLEANING
•
Clean the lamp with a damp cloth. Do not use detergents or any other chemical products as they could
damage the lamp's cover.
•
Do not expose the charger to water.
ELECTRICAL DATA
CHARGER :
100~240V AC, 50–60 Hz — 7,5V DC, 600mA
BATTERY :
Li-Po, 3,7V, 2400mAh
16/12/2019
EN
R
G
B
FLASH
W
STROBE
FADE
SMOOTH
19