Home Decorators Collection 99968 Guía De Uso Y Cuidado página 13

Operating Your Fan and Remote Control
Learning process
NOTE: After the AC power is on, do not press any other button on
the remote control before pressing the "FAN OFF" button (VV).
Doing so will cause the procedure to fail.
NOTE: The remote control can learn multiple receivers. Make
sure no other receivers are operating during the learning
process. Separate the fan power switches by approximately 2
meters.
□
Turn the main power source off to begin the learning process.
□
Return the power to the fan.
□
Within 30 seconds of turning the fan's power ON, press and hold
the "FAN OFF" button (VV) on your remote control for 10 seconds.
Once the receiver has detected the set frequency, the down light
of your fan, if applicable, will blink twice. There is no indication if
your fan is not equipped with a light.
□
To confirm the remote control and receiver have paired
successfully press the "1" button on your remote control.
Remote control operation
Light/Dimmer button (XX) = Press and release the button immedi-
ately to turn on or turn off the light. Press and hold the button to
dim or brighten the light to the desired level and then release.
(For tungsten bulbs only and down light function, turn the switch
to "DIM".)
1 = Low speed
2 = Medium speed
3 = High speed
Off button (VV)= Power off
Reverse button (WW) = Press and release the button immediately to
set the fan air flow direction up or down.
VV
WW
XX
13
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.