Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

The Com-Pak™ Bath Heater
OWNER'S GUIDE FOR MULTI-WATT MODELS
The Com-Pak™ Bath Heater
10" Width
Tools Required:
Phillips Screwdriver
Straight Screwdriver
Wire Strippers
WARNING
Turn the electrical power off at the electrical panel
board (circuit breaker or fuse box) and lock or tag
the panel board door to prevent someone from
turning on power while you are working on the
heater. Failure to do so could result in serious
electrical shock, burns, or possible death.
1. Read all instructions before using this heater.
2. Read all information labels. Verify that the electrical
supply wires are the same voltage as the heater.
3. All electrical work and materials must comply with the
National Electric Code (NEC), the Occupational Safety
and Health Act (OSHA), and all state and local codes.
4. Connect the grounding pigtail (copper wire) provided in
the wall can to the supply ground wire.
5. If you need to install a new circuit or need additional
wiring information, consult a qualified electrician.
6. Protect electrical supply from kinks, sharp objects, oil,
grease, hot surfaces or chemicals.
7.
WARNING
Overheating or fire may occur. DO NOT install the heater
in a floor, in the ceiling, below a towel bar, behind a door,
or anywhere the air discharge may be blocked in any
manner.
8.
WARNING
Fire or explosion may occur. DO NOT install heater in any
360-693-2505 Fax: 360-694-8668 P.O. Box 1675 Vancouver, WA 98668-1675
1/2" Depth
Utility Knife
4 1
/
" Wood Screws
1
2
3 Insulated Wire Connectors
1 Strain Relief Connector
IMPORTANT INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Features & Benefits
■ Primary and secondary thermal
safeguards
• High temperature manual reset
• Over temperature one-time thermal
device
■ Commercial grade steel element painted
to resist rusting
■ Built-in controls
• Single pole thermostat • 60 minute timer
■ Powder coat paint process eliminates
sharp cutting edges
■ Three year extended warranty on
element and motor.
■ Factory tested
■ Multi-Watt
• 1300–800–500 at 240 Volt AC
• 975–600–375 at 208 Volt AC
Models: The Com-Pak Bath Heater CBC132TW and CB132T
area where combustible vapors, gases, liquids, or
excessive lint or dust are present.
9.
WARNING
DO NOT install where heater is likely to get wet.
10.
WARNING
Heater must be connected to a GFCI protected branch circuit.
11.
WARNING
Burn Hazard. This heater is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. Use extreme
caution when any heater is used by or near children or invalids.
12.
WARNING
Risk of Electrical Shock. DO NOT install the heater
directly above bathtub or sink. DO NOT install in shower
stall area (Manufacturer recommends a minimum 2 foot
clearance).
13.
WARNING
Risk of Electrical Shock. Connect grounding lead to
grounding wire provided. Keep all foreign objects out of
heater.
14.
WARNING
Risk of Electrical Shock. Never place a switch where it can
be reached from the tub or shower enclosure.
15.
WARNING
Risk of Fire. Do not block heater. Heater must be kept clear of
all obstructions: a minimum of 3 feet in front, 6 inches above
and on both sides. Heaters must be kept clean of lint, dirt and
debris. (See Maintenance Instructions).

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Cadet The Com-Pak CBC132TW

  • Página 1 The Com-Pak™ Bath Heater OWNER’S GUIDE FOR MULTI-WATT MODELS Features & Benefits The Com-Pak™ Bath Heater ■ Primary and secondary thermal 10” Width safeguards • High temperature manual reset • Over temperature one-time thermal device ■ Commercial grade steel element painted to resist rusting ■...
  • Página 2 12 inches above the floor from the floor. However, Cadet RECOMMENDS 12 inches for longer and cleaner performance. Heaters must be from all adjacent wall surfaces and 12 inches from the supply wires are the spaced at least 3 feet apart.
  • Página 3: Installation Instructions

    Installation Instructions Part Two WARNING Multi-Watt Element Wiring Configuration: STEP 1 Turn the electrical Use the table on the right to select the correct wattage required, and element terminals to be used. power off at the electrical panel TIMER board (circuit breaker or fuse 1300 box) and lock or...
  • Página 4: Important Instructions

    These warranties give you specific legal rights, and you may also have other rights which vary from state to state. Cadet neither assumes, nor authorizes anyone to assume for it, LIMITED THREE-YEAR WARRANTY: Cadet Manufacturing Co. will repair or replace any...
  • Página 5: Guía Del Propietario Para Modelos De V Atiaje Múltiple

    The Com-Pak™ Bath Heater GUÍA DEL PROPIETARIO PARA MODELOS DE V ATIAJE MÚLTIPLE Características y Beneficios The Com-Pak™ Bath Heater ■ Protecciones térmicas primarias y secundarias Ancho de 10” • Reglaje manual de alta temperatura • Dispositivo térmico de sobretemperatura de operación única ■...
  • Página 6 4 " desde el distancia de todas las superficies adyacentes y 12 piso. Sin embargo, Cadet RECOMIENDA 12" desde pulgadas por sobre el piso para una vida útil más suministro eléctrico larga y un funcionamiento más limpio. Si se instalan...
  • Página 7: Instrucciones Para La Instalación

    ¡ADVERTENCIA! Desconecte la Instrucciones para la instalación electricidad en el tablero del panel Parte Dos eléctrico (caja de Configuración de cableado del elemento de vatiaje múltiple: STEP 1 cortacircuitos o Use la tabla de la derecha para seleccionar el vatiaje correcto necesario, y los terminales del elemento que se han de usar. fusibles) y trabe o coloque un cartel en la SI EL...
  • Página 8: Tabla De Resolución De Problemas

    GARANTÍA LIMITADA DE TRES AÑOS: Cadet Manufacturing Co. reparará o reemplazará otros derechos que varíen de un estado a otro. Cadet no asume, ni autoriza a nadie que todo calentador de baño serie Com-Pak Max (CBC) que se determine que está averiado o asuma en representación suya, ninguna otra obligación ni responsabilidad en relación...

Este manual también es adecuado para:

The com-pak cb132t

Tabla de contenido