GB
3 Getting Started
3.3
Setting time
and date
3.4
Adjusting the
voice function
3.5
Holder
3.6
ON/OFF switch
I/0
18
1. The date and time can be set with the device switched on ( ON/OFF switch
in I position ). Press the START button
simultaneously. The month appears on the display (flashing). To change the
month, press the MEM button
displayed. The value auto-repeats if the MEM button
Pressing the START button
hour and minute (flashing). Press the MEM button
values.
2. After the fifth press of the START button
stop flashing. The time setting is now complete.
3. The date and time must be reset if the batteries are replaced.
The voice function can be adjusted with the device switched on ( ON/OFF
switch
in I position ), i.e. with just the date and time displayed. Press and
hold down the MEM button
play (e.g. L1).
L0 = Language function switched off
L1 = German
L2 = English
L3 = Spanish
L4 = Dutch
L5 = French
L6 = Italian
L7 = Portuguese
The device speaks the language setting, and changes the display and the an-
nouncement to the next language if the MEM button
selected language can be changed by releasing the MEM button
as the language that you require is displayed or spoken. The selected volume,
which is indicated by flashing bars, can be modified by pressing the MEM
button
again and holding it down until the required volume is indicated –
the higher the bar, the louder the volume. Release the MEM button
confirm your selection. The bar stops flashing and the display switches back to
the time display.
Using the holder included with the unit you will store the arm cuff and the air
hose together with the device. First attach the adhesive pad to the rear side of
the unit, then fix the holder on it firmly.
Your device has a touch screen as an equipment. Be careful not to touch the
display by mistake. Keep the ON/OFF switch
is not in use to avoid unintentional adjustments.
and the MEM button
repeatedly until the required value is
again displays the values for month, day,
the numbers in the display
until the selected language appears on the dis-
in 0 position when the device
is held down.
to change the
is held down. The
as soon
to