Clarke FM-1700HD Libro De Instrucciones página 4

Ocultar thumbs Ver también para FM-1700HD:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
ENGLISH
WARNING !
Maintenance and repairs performed by unauthorized personnel could result in damage or injury. Maintenance and
repairs must be performed by authorized personnel only. Keep all fasteners tight. Keep adjustments according to
specifi cations.
Electrical components of this machine can "short-out" if exposed to water or moisture. Keep the electrical
components of the machine dry. Wipe the machine down after each use. For storage, keep the machine in a dry
building.
Always use a three-wire electrical system connected to the electrical ground. For maximum protection against
electric shock, use a circuit that is protected by a ground fault interrupter. Consult your electrical contractor.
To prevent damage to the power cord, do not let the brush, pad, pad driver or wheels touch the power cord when the
machine is running. Always lift the cord over the machine. Do not pull the power cord to move the machine.
Operating a machine without observing all labels and instructional information could result in injury or damage. Read
all machine labels before attempting to operate. Make sure all of the labels and instructional information are attached
or fastened to the machine. Get replacement labels and decals from your authorized distributor.
Use of this machine as a step or furniture could result in injury or damage. Do not use this machine as a step or
furniture. Do not ride on this machine.
To avoid injury keep hands, feet and loose clothing away from all moving parts of this machine.
Injury to operator or bystanders could occur if an abrupt change in fl oor surface texture is encountered when using
this machine. Abrupt change in fl oor surface texture can cause a sudden pulling motion by this machine. This
sudden pulling motion can result in loss of control of the machine which could injure the operator or bystanders.
Avoid motions that could cause machine to cross from a smooth fl oor surface to a carpeted or rough texture fl oor
surface Avoid motions that could allow the machine to come in contact with low obstacles, such as fl oor electrical
outlets, door stops or entry molding, etc.
Water solutions or cleaning materials used with this type of machine can leave wet areas on the fl oor surface. These
areas can cause a dangerous condition for the operator or other persons. Always put CAUTION signs near the area
being cleaned.
CAUTION !
The machine is heavy. Get assistance before attempting to transport or move it.
NOTE: This machine is intended for commercial use.
4 - FORM NO. 70831A
revised 12/2013
Clarke Operator's Manual FM-1700HD HDTR

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Fm-1700hdtr01278a

Tabla de contenido