How To Operate The Machine - Clarke FM-1700HD Libro De Instrucciones

revised 4/2015
Figure 7
Handle
Before May 2015
Figure 8-1
Handle
After April 2015
Figure 8-2
Apply pressure to lock
Figure 9
Clarke Operator's Manual FM-1700HD HDTR

HOW TO OPERATE THE MACHINE

WARNING: Machines can cause fl ammable materials and
vapors to burn. Do not use this machine with or
near matches, fuels, grain dust, solvents, thin-
ners, or other fl ammable materials.
CAUTION: This machine will operate only on the AC fre-
quency and electrical voltage shown on the
nameplate. Make sure you have the correct
frequency and voltage before connecting the
power cord to an outlet.
NOTE: You must have training in the operation of this machine before
you use this machine.
POSITION OF THE HANDLE
FOR OPERATION
Lift the locking lever to unlock the handle. Lower the handle to the best
position. Bend your arms and keep your back straight. To fasten the
handle, press down on the locking lever with your foot. Hold the handle
against your body for the best control. See Figure 7.
HOW TO CONTROL THE MACHINE
NOTE: Make sure you hold the handle with both hands.
The side to side movement of the machine is controlled by raising the
handle and pressing down on the handle. To move the machine to the
left, press down on the handle slightly. To move the machine to the right,
raise the handle slightly.
HOW TO START/STOP THE MACHINE
WARNING: Never start a polisher when the handle is in the
vertical position.
The switch to start and stop the machine is activated by the interlock
switch and the levers under the handle grips. See Figures 8-1 & 8-2. To
start the machine, follow this procedure:
1. Lower the handle.
2. Lock the handle in the best position for operation. See Figure 9.
WARNING: Control the safety interlock switch with hands
only.
NOTE: Make sure you hold the handle with both hands.
3. Push the interlock switch, and apply pressure to the levers.
NOTE: Hold the handles loosely for the best control of the machine.
Too much movement makes the machine diffi cult to control.
WARNING: Water solutions or cleaning materials used with
this type of machine can leave wet areas on the
fl oor surface. These areas can cause a danger-
ous condition for the operator or other persons.
Always put CAUTION signs near the area being
cleaned.
EN
ENGLISH
FORM NO. 70831A - 7