Accessories; Maintenance Of The Machine; Lubrication; Motor And Gears - Clarke FM-1700HD Libro De Instrucciones

EN
ENGLISH

ACCESSORIES

These different brushes and attachments are available for the
Model FM Floor Maintainer:
1. Brushes with natural or synthetic bristles for polishing.
2. Brushes with natural or synthetic bristles for scrubbing.
3. Brushes with steel wire bristles.
4. Synthetic pad holders.
5. Synthetic pads for polishing, scrubbing, stripping, etc.
6. Lambs wool polishing pads.
7. Brushes with metal or wood backs, and with holes to let the
solution go through.
8. Solution tank.
9. Attachments for spray buffi ng.
10. Sanding, grinding, and carpet scrubbing accessories.
DANGER: Fine dust from a fl oor sanding operation
can cause an explosion. Use a fl oor sand-
ing machine only in an area with good ven-
tilation.
For more information, see your dealer or the nearest Clarke
branch.

MAINTENANCE OF THE MACHINE

WARNING: Maintenance must be done by authorized
personnel only.
Clean your machine frequently. It will have longer life and need
fewer repairs.

Lubrication

The Polisher is completely lubricated. The bearings and gears
in the gear unit have enough lubricant for two or three years of
normal operation. All other bearings are sealed and have enough
lubricant for the life of the machine.

Motor And Gears

Remove or blow dust and dirt from the motor frequently.

Repairs

If repairs to the gear unit or motor are needed, do not disassemble
the gears and motor! Return the machine to the nearest Clarke
Service Branch or Clarke Authorized Service Center.
8 - FORM NO. 70831A

Maintenance Inspection

Return the machine to a Clarke Authorized Service location every
12 months for maintenance inspections.

Lever To Lock The Handle

The locking mechanism for the handle can become loose. Tighten
the nut on the end of the cross link bolt. The pressure of the lock-
ing lever is correct when the handle can be adjusted easily and
fastened as needed.

Maintenance Of Brushes

Always remove the brush from the machine when not in use. Keep
brushes in a cool, dry location. Heat can damage the wood and the
bristles. Scrub brushes with bassine fi bers must be put in water for
16 hours to replace moisture and give the bristles a longer life.
WARNING: Maintenance must be done by authorized
personnel only.
WARNING: Disconnect the electrical plug from the
electrical outlet before doing any repairs
or maintenance to the machine.
Clean your machine frequently. It will have longer life and need
fewer repairs. Replace damaged or worn parts with the correct
Clarke parts.
CAUTION: Keep all fasteners tight. Keep all adjust-
ments according to specifi cations.
Switches
WARNING: All electrical repairs must be done by
authorized personnel only. The machine
must be tested after electrical repairs are
made to make sure it is safe to operate.
Disconnect the electrical plug from the
outlet before doing any electrical repairs
to this machine.
The start and stop switches are in the handle. If any part of the switch is
not operating, replace the part. If any part of the electrical system of the
machine is not operating or is damaged, replace the part. Make sure all
connections are tight. Return the machine to a Clarke Service Branch or a
Clarke Authorized Service Center for electrical repairs and testing.
Clarke Operator's Manual FM-1700HD HDTR
revised 4/2014