GE AGH18 Manual Del Propietario E Instrucciones De Instalación página 12

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALL THE WINDOW LOCKING
7
BRACKET AND THE FOAM TOP
WINDOW GASKET
Attach a support bracket with a Type C
A
screw.
Cut the foam top window gasket to the
B
window width.
Stuff the foam between the glass and the
C
window to prevent air and insects from
getting into the room.
INSTALL THE AIR CONDITIONER
8
IN THE CASE
Slide the air conditioner into the case.
A
Reinstall the 2 screws removed earlier
on each side of the case.
Screw
Power cord
Installation Instructions
Screw
12
INSTALL THE AIR CONDITIONER
8
IN THE CASE (CONT.)
Before installing the front grille, pull out the
B
vent control lever located above the unit
control knobs, as shown.
Attach the front grille to the case by inserting
C
the tabs on the grille into the slots on the
front of the case. Push the grille in until it
snaps into place.
Guide the lever
carefully through
the grille as you
push it in.
Lower the inlet grille and secure the front
D
frame with a type A screw through the
front grille. Raise the inlet grille back
into place.
Inlet grille

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Agw18

Tabla de contenido