Blade And Emulsifying Disc; Whisk; Aluminum; Plastic - Robot Coupe Mini MP 160 V.V. Manual De Instruccion

• BLADE AND EMULSIFYING DISC

The Blade and the emulsifying disc can be removed
from the bell for thorough cleaning. Always dry
thoroughly to avoid spotting.

• WHISK

The whisks can be cleaned either by hand or in a
dishwasher.
Never immerse the gear box in water or in a dish-
washer.
Clean it with a slightly damp cloth or sponge.

• ALUMINUM

Use soft-metal-safe cleaning agents!

• PLASTIC

Be careful, many cleaning agents are corrosive and
are not safe for use on plastics !
Do not use strong alkaline detergent (having a high
concentration of soda or ammonia).

• BLADE

Over time the blades will become worn and will
need to be replaced. The washer and seals should
also be replaced at this time. A blade service kit is
available.
• WHISK
The success of your preparation will depend essen-
tially on the state of the metal wires and their amount
of wear and tear. They should therefore be replaced
from time to time in order to ensure optimum quality
of the finished product.
10

• SHAFT SEAL

In order to maintain a watertight seal between the
shaft and bell, inspect the seal for wear and replace
it if necessary.
THE POWER MIXER DOES NOT START.
- Did you follow the previous operating instructions
See section-Operating The Power Mixer.
- Pull the plug and try another outlet.
- Check outlet for current (breaker or fuse).
- Call local Robot Coupe authorized service agency.
THE POWER MIXER STOPS DURING (WHILE)
PROCESSING.
See the section on Operating the power Mixer. The
first paragraph describes the overload protection. It
may be necessary to allow the machine to cool for
up to 30 minutes before restarting.

MAINTENANCE

If you cannot locate the cause of the problem
- Release the control button (CB).
- Unplug the power mixer.
- Are the blades free to rotate in the bell
- Is the drive shaft free to rotate
unplug the power mixer, remove the bell and test
the rotation of the end of the drive shaft manually.
Check the condition of the plug and the power cord.
THE POWER MIXER STARTS TO SMELL HOT OR
SMOKE.
Turn the power mixer off and unplug it. Call your
local authorized service agency.
THE BLADES ARE SHARP! It is recommended that
cutting gloves be worn when handling the blades.
Handle and store the blades with safety in mind.
Never try to override or defeat the purpose of the safety

TROUBLE SHOOTING

mechanisms!
Never put anything (utensils etc.) but food material near
the blades on the power mixer!
Never overload the power mixer!
Never turn the power mixer on, unless the bell is
completely immersed in the product.
Always unplug the power mixer before doing any
cleaning or maintenance!
Unplug the power mixer whenever it is not being used.
Plug the power mixer only into a GFI type outlet. Never
use extension cords.
See warranty first then;
Should your unit require service, check with
your distributor to see where local service is
available. If not or if you wish your unit to be
serviced at the factory, call for return instructions and
ship the unit prepaid to our factory address.
To check this,
For service in Canada contact the Robot-Coupe
W A R N I N G

SERVICE

PH : 1-800-824-1646
Robot-Coupe USA, Inc
Service Department Repair
264 South Perkins Street
Ridgeland, MS 39157
USA factory for repair instructions.