Working Position; Assembly / Disassembly - Robot Coupe Mini MP 160 V.V. Manual De Instruccion

WORKING POSITION

For a more ergonomic
approach, we recommend
that you hold the handle of
the appliance in one hand
and the container with the
other. It is a good idea to tilt
the power mixer slightly,
making sure that the bell
does not touch the bottom
of the container.
Always make sure that the bell is sufficiently immer-
sed to avoid splashing and that the air vents of the
motor unit do not come into contact with any liquid.
For optimum efficiency, two thirds of the shaft should
be immersed in the preparation.
Do not rest the bell against the bowl.
The splashguard should always be in place.
• WHISK FUNCTION
We recommend that you
hold the power mixer by the
handle and the bottom of
the motor unit.
You can also hold the
appliance by the handle
with one hand, leaving the
other hand free to hold the
bowl, if necessary.
While processing we recom-
mend that you move the
whisk around in the bowl, in
order to ensure that the mixture is completely
homogeneous. Avoid touching the whisk to the side
of the bowl. For maximum efficiency, at least
one-fifth of the whisk length should be immersed.
Always start processing at low speed.
ASSEMBLY /
DISASSEMBLY
• MIXER ASSEMBLY
Attaching the shaft to the motor unit.
- Unplug the power mixer.
- Note that each end of the shaft has a threaded
plastic piece. One is longer than the other and
doesn't have a rubber "O" ring. Insert this longer
A
plastic end into the motor housing
turn the shaft in the direction of the arrow until it is
tight.
Mini MP 160 V.V.
Mini MP 190 V.V. / 190 Combi
Mini MP 240 V.V. / 240 Combi
Removing the shaft from the motor unit
- Unplug the power mixer.
- Turn the shaft counterclockwise until it is removed.
Attaching the bell to the tube
- Unplug the power mixer.
- Insert the threaded shaft
the bell. Turn the bell in the direction of the arrow
(see drawing) until it is tight.
TURN TO ATTACH BELL
A
B
, and
Removing the bell from the tube
- Unplug the power mixer.
- Turn the bell in the direction of the arrow (see
drawing below) to detach it from the tube.
B into the housing A of
B
Mini MP 190 V.V. / 190 Combi
Mini MP 240 V.V. / 240 Combi
TURN TO REMOVE BELL
Mini MP 190 V.V. / 190 Combi
Mini MP 240 V.V. / 240 Combi
7