dirna Bergstrom Bycool COMPACT 3.0 Instrucciones De Montaje página 17

COMPACT 3.0
OUTSIDE CABIN:
5
Position Compact in sun hatch hole.
Caution! When positioning the unit above
the hatch gap, check that the wastewater
run-offs are not blocked by the EPDM
seal.
To place the foam rubber ducting remaining at
6
the softer part of the base.
INSIDE CABIN:
7
Screw about 5 mm (4) 8/125x70,100 or 120
mm studs, the exact measure is chosen after
the fastening supports have been presented
and taking into account that studs must stick
out of lower part about 20 mm.
Following this order:
8
- plane rubber wash
- plane ruber wash wide wing diameter 8
- nut M8
- plane washer diameter 8 wide wing
Air conditioning for vehicles
Sun hatch
6
Unit base
7
7
plane ruber wash
plane rubber
wide wing Ø 8
wash
8
17
5 mm
Stud
Bracket
20 mm
plane washer Ø8
wide wing
nut M8
EN ES
5
7