Installing A Replacement Cartridge Filter - Craftsman 125.12008 Manual Del Operador

Maintenance (continued)

Installing A Replacement Cartridge Filter

Craftsman Filter with Rubber Top
1 2
THIS VACUUM CLEANER IS DESIGNED TO USE CRAFTSMAN CARTRIDGE FILTERS.
1. Carefully slide the Craftsman cartridge
fi lter over the fi lter cage and press
down on the outside edge of the fi lter
until the rubber gasket on the bottom of
the fi lter fi ts securely around the base
of the fi lter cage and against the lid.
(Fig. 1)
2. Align the small center hole in the top of
the fi lter over the post on the fi lter cage.
Press fi rmly on top of the fi lter near the
post to allow the fi lter to seat over the
post. (Fig. 2)
3. To further secure fi lter, put on retainer
nut and turn clockwise to tighten until
snug. (Fig. 3)
NOTE: Always retain the original retainer nut. Do not misplace it while removing or replacing
the cartridge fi lter.
3
13
Craftsman Filter with Plastic Top
1a 2a
1. Carefully slide the Craftsman cartridge
fi lter over the fi lter cage with the fl at end
of the fi lter towards the power head. (Fig.
1a)
2. Carefully push fi lter down until it is fully
seated on the power head. (Fig. 2a)
3. To secure fi lter; put on retainer nut and
turn clockwise to tighten until snug. Do
not over tighten. (Fig. 3a)
3a