RedMax TRZ230S Manual Del Usuario página 3

13. Idle adjustment screw
14. Trimmer head
15. Spacer
16. Drive disc
17. Cutting attachment guard
18. Bevel gear
19. Screws
20. Shaft
21. Locking pin
22. Hex key
23. Combination wrench
24. Operator's manual
Symbols on the product
WARNING! This product can be dangerous
and cause serious injury or death to the
operator or others. Be careful and use the
product correctly.
Read the operator's manual carefully and
make sure that you understand the
instructions before use.
Use a protective helmet, approved hearing
protection and approved eye protection.
Use approved protective gloves.
Use heavy-duty slip-resistant boots.
The product can cause objects to eject,
which can cause injury.
Keep a safety distance at a minimum of 15
m to persons or animals.
Only use flexible cutting wire. Do not use
metal cutting attachments.
Risk of blade thrust if the cutting equipment
touches an object that it does not
immediately cut. The product can cut off
body parts.
1559 - 003 - 01.10.2020
The arrows show the limit for the handle
position.
Choke, open position.
Choke, closed position.
Only use nonmetallic flexible cutting
attachments.
Mixture of gasoline and two-stroke oil.
yyyywwxxxx
Note: Other symbols/decals on the product refer to
certification requirements for some markets.
EPA III
2019
Husqvarna Zenoah Co.,Ltd.
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal emissions requirement. Maintenance,
replacement or repair of the emission control devices
and system may be performed by any nonroad engine
repair establishment or individual.
The rating plate shows the
serial number. yyyy is the
production year, ww is the
production week.
25cc
KHQZS.0254HD
KHQZS.0254PA
TWC SP
300h
Jan. 2019
3