Maintenance - RedMax BB-EX600 Manual Del Usuario

3. When adjusting the carburetor, make sure that the
brush drums are held against the ground and that no
one else is in the vicinity.
4. Make sure the brush drums are idling.command.
5. Make sure that the handle and safety features are in
good working order. Never use a product that lacks a
part or has been modified outside its specifications.
To use the attachment
1. Run the product at full gas (or nearly full gas) with
the brush resting on the surface.
Note: It is both tiring and unnecessary to lift or hold
the brush above the surface when working.
2. When clearing narrow surfaces such as paths, the
product can be used so that it throws materials
straight in front of you. If you want to work on wider
surfaces, you may need to work at an angle so that
strands form on one side. Strands comprising light
materials can be collected into one row or pile for
later removal while hard or more bulky materials may
need collecting in several strands.command.
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To perform maintenance on the
attachment
CAUTION: Working on the sweeper is often
done in dusty conditions. It is extremely
important to take care of air filter
maintenance regularly, often daily. The air
filter must be oiled to work
satisfactorily.Refer to the product's
operator's manual for maintenance
instructions.
412 - 003 - 23.01.2020
3. In order to get into corners, remove the splash guard
and loosen the accessory coupling and rotate the
accessory half a turn.
4. Keep a small working angle to the surface. Too large
a working angle means the sweeper tends to move
towards you and you risk losing control of the
product.

Maintenance

1. Check that the brush drums do not rotate at idle.
2. Check that the brush drums are not damaged or
cracked. Replace the brush drums if necessary.
3. Hang up the brush when in storage for long periods.
WARNING: Rubbish will then be thrown
back towards the user. Use a lower
speed when reversing the product and
remember that it is easy to trip over
WARNING: The gear housing gets hot when
the product has been in use. To avoid
burning yourself do not touch the gear
housing.
7