Tabla de contenido
Publicidad
40 OZ. BLEND AND PREP BOWL
A
B
CAUTION: BLADE ASSEMBLY IS
NOT LOCKED IN PLACE. IF USING
THE POUR SPOUT, ENSURE THE
LID IS FULLY LOCKED ONTO THE
BLEND AND PREP BOWL.
ASSEMBLY OF
ASSEMBLY:
THE BLEND AND
WARNING: NEVER LEAVE THE APPLIANCE
UNATTENDED WHILE IN USE.
PREP BOWL
CAUTION: USE CAUTION WHEN
HANDLING THE BLADE ASSEMBLY AS IT
NOTE: Ninja
Auto-iQ
®
™
IS VERY SHARP.
Technology can sense
which container is on
IMPORTANT: MAKE SURE THE MOTOR
the motor base. The
BASE IS PLUGGED IN FOR USE.
function lights will
1
Holding the desired blade assembly by the
illuminate depending
top of the shaft, place it onto the drive gear
on which container is
(A) inside the Bowl. Ensure the attachment is
placed on the motor
seated properly and is standing upright.
base.
NOTE: THE BLADE ASSEMBLY WILL FIT
LOOSELY ON THE DRIVE GEAR.
1 0
®
C
D
ASSEMBLY
ASSEMBLAGE
ARMADO
CAUTION: THE BLADE
ASSEMBLY IS NOT LOCKED IN
PLACE. IF POURING WITH THE
LID REMOVED, ALWAYS REMOVE
THE BLADE ASSEMBLY FIRST.
2
Place the motor base on a clean, dry, level surface
such as a counter or tabletop. Press down on the
motor base to make sure the suction cups adhere to
the counter or tabletop.
3
Align and lower the Blend and Prep Bowl (B)
onto the motor base. Handle should be aligned
slightly to the right of the LOCK symbol on the
motor base.
4
Rotate the Bowl clockwise (C) until it locks in place
(you will hear a click when the lock is engaged).
5
The Bowl can be placed on the motor base
two ways; the handle can be on the front right
corner (D) or the front left corner (E).
w w w . n i n j a k i t c h e n . c o m
or
ou
y
E
F
IMPORTANT: DO NOT
OVERFILL. TO AVOID SPILLING,
DO NOT ADD INGREDIENTS
PAST THE "MAX LIQUID" LINE.
6
Add the ingredients to the Bowl, making sure
that they do not exceed the highest measured
marking line on the side of the Bowl.
7
Holding the lid by the handle in the upright position
(F), place it on top of the Bowl aligning the triangle
( ) located on the lid with the triangle ( ) located
on the Bowl handle. Press the handle down until
you hear a click.
8
The triangles on the lid and the Bowl handle
MUST be aligned in order for the blender to
turn on.
9
Plug the power cord into the electrical outlet.
The function lights will illuminate.
Publicidad
Tabla de contenido
