Bridge.surface.element - GE PP912 El Manual Del Propietario

Using the surface elements.
The dual surface element has 2 cooking sizes to select from so you can match the size of the element to the size of the cookware you are
using.
Small
Large
surface
surface
element
element
setting
setting
The Tri-Ring surface element offers 3 cooking areas to match the size of the cookware you are using.
8
Dual Surface Element with Selector Knob
To use the large surface element, turn the
SELECTOR knob to . Push in and turn the
control knob to the desired setting. The element
will heat the entire area contained by the larger
circle.
Dual Surface Element without Selector Knob
To use the small surface element, turn the
control knob to the settings.
To use the large surface element, turn the
control knob to the settings.
Bridge Surface Element with Selector Knob
You can create an oblong heated area by using
the left rear element in addition to the front
element bridge combination.
Make sure the pan rests flat on the glass
cooktop.
When the SELECTOR knob points to
control knob controls both the left front surface
element and the bridge area.
Bridge Surface Element without Selector Knob
Make sure the pan rests flat on the glass
cooktop.
To use the bridge element, push and turn the
control knob to , stopping at the desired
settings.
Tri-Ring Surface Element with Selector Knob
To use the largest cooking area, turn the
SELECTOR knob to . Push and turn the
control knob to the desired setting.
To use the medium cooking area, turn the
SELECTOR knob to .
Push down and turn the control knob to the
desired setting.
(on some models)
To use the small surface element, turn the
SELECTOR knob to . Push in and turn the
control knob to the desired setting. The element
will only heat the area inside the smaller circle.
(on some models)
(on some models)
Choose pans that match the circle/bridge area
as closely as possible.
When the SELECTOR knob points to
control knob controls the left front surface
element only.
, the
(on some models)
Choose pans that match the circle/bridge area
as closely as possible.
To use the left front surface element only, push
and turn the control knob to
the desired settings.
(on some models)
To use the smallest cooking area, turn the
SELECTOR knob to . Push and turn the control
knob to the desired setting. This will activate
only the smallest inside heating area.
, the
, stopping at