Starting The Engine - Efco PTX 2710 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

en
35 ft
50 ft
F
H
E
18
OPERATION
Work Area Precautions
• Never allow children to operate your pole pruner. Only allow
44
• Keep everyone - helpers, bystanders, children, and animals a
• Always cut with both feet on solid ground to prevent being
• Do not cut above chest height, as a pole pruner held higher is
• Do not work near electrical wires or buildings. Leave this
• Cut only when visibility and light are adequate for you to see
• Do not cut from a ladder, this is extremely dangerous.
• Stop the pole pruner if the chain strikes a foreign object.
45
• Keep the chain out of dirt and sand. Even a small amount of
• Stop the engine before setting the pole pruner down.
• Be particularly cautious and alert while wearing hearing
• Be extremely cautious when working on slopes or uneven

Starting The Engine

45A
C
• Do not start the engine with the arm not mounted.
D
• Place the pole pruner on level ground and ensure that no
G
Start-up procedure
46
1) Slowly push the purge bulb 4 times (C, Fig.46).
2) Pull the choke lever (D, Fig.46) in the CLOSE position (A, Fig.45)
3) Pull the throttle lever (E, Fig.46) and stop it at half-throttle by
4) Place the pole pruner on the ground in a stable position. Check
5) Push the choke lever (D, Fig.46) in OPEN position (B, Fig.45).
6) Pull the starter cord to start the engine. Once the machine is
WARNING: Cut only wood or materials made from
wood. Do not cut metal, plastics, masonry, or
non-wood building materials.
others to use this pole pruner who have read this Operator's
Manual or received adequate instructions for the safe and
proper use of this pole pruner.
safe distance from the cutting area (Fig. 44).
pulled off balance.
difficult to control against kickback forces.
operation for professionals.
clearly.
Inspect the pole pruner and repair parts as necessary.
dirt will quickly dull a chain and increase the possibility of
kickback.
protection because such equipment may restrict your ability to
hear sounds indicating danger (calls, signals, warnings, etc).
ground.
WARNING: Keep body to the left of the chain line.
Never straddle the pole pruner or chain, or lean over
past the chain line.
objects or obstructions are in immediate vicinity which could
come in contact with the bar and chain.
Hold the body of the machine on the ground using your left
hand (CAUTION! Not with your foot!), see Fig. 45A.
pressing the button (F), then release the lever (E).
that the cutting attachment is free. Holding the pole pruner
down (Fig.45A), pull the starter rope until the first kick over of
the engine is heard (no more than 3 pulls). A new unit may
require additional pulls.
started, warm up the machine for about few seconds, without
touch the throttle lever. The machine could need more seconds

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido