Using The Machine - Inoksan BYM102 Manual De Usuario

 Be mindful of the durableness of the dishes that you
will put inside the Dishwashing Machine.
 Never change the location of the machine while it
is operating.
 Be sure that the water input valve is open before
operating the machine.
 Cleaning of the internal parts of the machine
periodically is recommended.
 In order to obtain healthy results in cleaned dishes,
the following ground rules must be met.
 Apply the manufacturer's remarks on the detergent
dosage according to the water hardness.
 The wash water must be renewed at least 3 times a
day or when the water loses its ability to clean due
to dirty particles. Washing performed with dirty
wash water causes bad washing results, along with
detergent, polisher and power wastage.
 Do not dry cleaned dishes with a dirty towel.
 Do not place clean dishes on spongy towels or other
materials.
 Use disposable materials or preferably the basket
system.
 Make the constant cleaning of the shelves that you
use for storing dishes with special detergents and
disinfectants available in the market.
NOTE: The choice of detergent can be a
determining factor in getting a good wash result,
protection and lifetime of the machine. Therefore
we recommend
contaminating products and not exceeding the
suggested detergent amount.

USING THE MACHINE

6.
6.1- Operating
Press the On button to start. Select (low, mid, high)
by pressing the wash program button. Close the
door after inserting the tray inside. Press the
START/PAUSE button. When the program ends, a
verbal reminder
START/PAUSE button in order to stop the
machine between programs. Canceling the wash
can be performed by holding down the
START/PAUSE button.
NOTE: For an ideal washing result, you should
wait until the ready-led is lit, when the boiler
reaches 85°C and the tank reaches 55°C.
NOTE: USA for in ideal washing result, you
should wait until the ready-led is lit, when the
boiler reaches 185°F and the tank reaches 158°F.

1 ON button (OFF when pressed for
2 sec) Red when Stand-by, green when
operating

START <–> PAUSE (2 sec STOP):
Green when operating, blinks when
paused
not using abrasive
is played. Press

Tank Temperature indicator

Ready-led:Will flash red when Boiler and
Tank temperatures are ready

Less dirty buttonwill flash red when
selected

Dirty buton will flash red when selected

Very dirty buton will flash red when
selected

Rinse led Will flash red during rinsing

Boiler temperature: Red double digit

Drain button

Will flash red during manual or automatic
draining

ON

WATER INTAKE: Fill water with the
Y1+M2 valve. Boiler and Tank is full
when P1-Pressure stat is seen. (6lt.)

HEATING : First the Boiler is heated,
then the Tank is heated

READY: START will be permitted when
Boiler and Tank reach the correct
temperature
Heaters are active during the waiting
process. (Prm. Option : Permit START
when not ready)

START

WASHING:M1 Washing engine active
or
(Heating active)

FILTERING: ~5 sec wait (Heating active)

RINSING: Y1(Water intake) and M2
(Rinsing pump) active + PD (Polisher)
output active ( Heaters passive)

FILTERING: ~5 sec wait (Heating active)

FINISH: START led flash (Heating active
for the next wash)

MANUAL DISCHARGE: When the
the
device is on or in standby mode, plastic
plug in the tank is removed and
DISCHARGE button is pressed during 2
seconds. Discharge button blinks, which
is a sign that the process has started.
When the process is over, the device shuts
off automatically (it goes into OFF mode.)
10
Red double digit