allen+roth 1227VA-60-201-903 Manual De Instrucciones página 5

INSTALLATION INSTRUCTIONS
2. To remove drawers preassembled in vanity (A),
fully extend drawers. Locate plastic levers on
metal glide tracks at left and right sides of
drawer box.
To disengage drawer box from glides, push on
plastic levers. Then, gently lift drawer up to
remove it from vanity (A).
3. With the help of another person, place
vanity (A) upside down on a scratch free
surface. Place leg (B) and mid-back leg (I)
into correct position on vanity (A). Insert
bolts (AA), short bolt (JJ), spring washers (EE)
and washers (BB) into the predrilled holes on
the inside of the vanity (A). Tighten bolts (AA)
and short bolt (JJ) with allen wrench (DD).
Repeat for additional one leg (B); DO NOT
install the final two legs (B).
Hardware used
Bolt
AA
Washer
BB
Allen wrench
DD
Spring washer
EE
Short bolt
JJ
2
A
1
3
B
x 4
x 5
x 1
x 5
x 1
5
2
DD
JJ
DD
EE
AA
BB
EE
1
I
BB
1
1
A
1
1
2
2