Built-In Cabinet Instructions - Climadiff AVINTAGE AV24XI-1 Manual De Utilización

Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may
affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may
also cause the unit not to perform properly.
Plug the Wine Cooler into an exclusive, easily accessible plug socket. Any questions concerning power and/or earthing
should be directed towards a qualified electrician or an authorized products service centre.
To prevent the appliance from heating up, ensure that an adequate ventilation gap is retained and install a suitable
thermal insulation panel. An adequate flow of air to and from the cooling system must be ensured.
The appliance must be installed to all electrical, plumbing, water and drain connections in accordance with state and local
codes.
The required room temperature to allow proper operation of the device must be between 16 ° and 38
NOTE: Make sure that the socket and ON/OFF switch are easily accessible after the appliance has been
installed.

BUILT-IN CABINET INSTRUCTIONS

The wine cooler door seals the installed unit almost completely, so an air vent must provided in the base of the housing.
Warmed air must flow from the front of the device to the back
measure at least 200 square centimeters in cross-section.
WARNING: To ensure the proper functioning of the appliance, air vents should never be blocked or covered.
Model 88 cm
and then expelled upwards. The ventilation channels should
Model 122 cm
°C.
28