Instructions Of Use; Steam Ironing; Dry Ironing; Maintenance And Cleaning - Jata electro CP537 Instrucciones De Uso

INSTRUCTIONS OF USE

• For a correct functioning the appliance must be on a flat surface.
• With the help of a bottle or a jug or directly from the tap pour water into the tank (10). In the
case of very hard waters you may use distilled water.
• Set the iron temperature selector (5) to its maximum position (MAX) by turning it clockwise. If
you wish a lower temperature on the sole plate leave the temperature selector in (
• Plug the appliance into the mains and push the iron on switch (7) and the boiler on switch (8),
both switches will light on, the steam indicator light (9) starts flashing and the iron indicator light
(4) will light on.
• When this operation is done, the iron and the steam chamber will start heating.
• Await until the steam pilot light (9) change from flashing to get fixed and the iron pilot
light (4) goes off. At this moment the appliance is ready to be used.
OUTLET STEAM SELECTOR
• The steam outlet selector (2) has two positions. You can select the desired steam by turning this
selector:
Position ( ): Steam.
Position ( ): Frontal steam.

STEAM IRONING

• Remember that the iron temperature selector (5) must be set to its maximum position or in the
steam position (
• Press with the index finger the steam button (1) for the steam begin to flow. It is advisable to use
the button in short intervals.
• The steam caudal can be regulated at any moment using the regulator (11).
ATTENTION:
When pressing the steam pusher the pump starts to pass water intermittently to the
steam chamber. This intermittent noise of the pump is absolutely normal.
• When the water level is down, the low water pilot light (10) will start to light on intermittently
and it will stop the pump noise. You can fill the tank.
• You can fill the tank at any moment bearing in mind that you must unplug the appliance from
the mains while doing it. If you have the precaution for keep the tank always with water, the
appliance can work in a continuous way, without need of waits.
• The pressure, the steam flow and the automatic load of the steam system suppose the appliance
can work in a continuous way, make this appliance irreplaceable for any type of ironing, including
thick garments or great dimensions.
• You can also iron curtains and other garments vertically without needing to take them down.
Bring near the iron in vertical position to the garment and press the steam outlet button (1).
NOTE: When using the frontal steam, some drops of water can appear in the steam outlet area due
to the steam condensation.

DRY IRONING

• Plug the appliance into the mains, push the on switch (7) and set the temperature selector (5) in
the desired position.
FIBRAS SINTÉTICAS / SINTHETIC FIBRES: Soft temperature (•)
SEDA – LANA / SILK – WOOL:
ALGODÓN – LINO / COTTON – LINEN: High temperature (•••)
• When the indicator light (4) is switch off, the iron has reached the selected temperature.
• Do not press the steam pusher.
NOTE: if during dry ironing the tank doesn't have water and the pusher of the boiler is on, the refill
indicator light will be flashing.

MAINTENANCE AND CLEANING

• Before you proceed to cleaning the appliance, ensure it is unplugged from the mains.
• Do not empty the water thank may kept in the tank, unless you are not going to use the appliance
for a long time.
).
Medium temperature (••)
11
) position.