Trial Operation - INVENTOR QLT-500 Manual Del Propietário

|Trial operation

Notes
• This appliance is provided with a disassembly protection function; the appliance can only
operate normally after the air inlet grill and air outlet grill are assembled properly.
• I n case of continuous electricity, enter the working mode before the standby state, after
each power on.
• The appliance is connected to the power again after unexpected power outage (when the
power is off or the power cord is unplugged during normal operation), and then restores
to the working state before the power outage.
1
Preparations
P ower on for the first time, the
display panel flashes for 1s, and
then the screen is turned off. The
whole appliance is the standby
state;
2
Switch
Press the ON/STAND-BY Button
ON/STAND-BY
EN
Replace
Clean Fair Poor
True HEPA
Check
Pre-Filter
3
Pre-heating
The VOC sensor is preheated,
Clean, Fair and Poor are displayed
alternately, and then displayed
normally after 1min
The particle sensor enters the
preheating state, PM2.5 displays
Clean, Fair and Poor are displayed
alternately, and then displayed
normally after 10s;
4
Work
T he purifier is powered on for the
first time and then enters the AUTO
mode.
Clean Fair Poor
Replace
Clean Fair Poor
True HEPA
Check
Pre-Filter
7