Cleaning & Maintenance; Troubleshooting - Pur Line CHE-610 Manual De Usuario

CLEANING & MAINTENANCE
• WARNING: Switch off the power supply and disconnect from mains supply
when not in use, before cleaning or other maintenance.
• Always switch off the device and disconnect the power cord before cleaning.
• Let the heater cool down completely.
• Never immerse it in water or other liquid. Do not allow water to run into the
appliance.
• Clean your heater with a soft damp cloth. Use a vacuum or duster to keep vent
area clean from dust and dirt.
The glass viewing screen should be cleaned carefully with a soft cloth.
• Do not clean the appliance with abrasive chemicals.
• Clean the appliance regularly.

TROUBLESHOOTING

Problem
The unit does not turn on
Flame effect is on, but there is no
flame effect
The heater does not blow warm air Make sure the set temperature is higher than the room temperature.
The heater does not work
Remote control does not work
WARRANTY
The benefits conferred by this warranty are in addition to all implied warranties, other rights and
remedies in respect of the product which the consumer has under the Trade Practices Act and
similar State and Territory Laws. The original purchaser of this product is provided with the follow
warranty, subject to the following conditions. This product is warranted for a period of 2 years from
faulty, the product will need to be returned to the retailer where it was purchased to be replaced
free of charge or a refund issued. In order to obtain an exchange or a refund, proof of purchase
must be presented to the retailer.
DISCARDING WORN HOUSEHOLD DEVICES
The European directive 012/19/EC pertaining to electrical and electronic waste prohibits such household goods from being
discarded with local refuse services. Worn devices must be collected separately to optimize the recovery and recycling rates
of the components therein to reduce detrimental effects on the environment and on human health.
EN
Solution
Make sure the unit is correctly plugged, and the main switch is in
position I. Press the power button on the control panel.
Open the top and back panel to check if the flame spindle has fallen off
from the spindle motor.
Turn all switches to OFF and unplug the unit for 5 minutes. Plug the
unit back to power and operate as normal.
Use it closer to the unit / change battery / remove insulating plastic
sheet.
13