Mounting On A Table; Tidying Cables - LG 42CM565 Manual Del Usuario

18
ASSEMBLING AND PREPARING

Mounting on a table

1
Lift and tilt the TV into its upright position on a
table.
- Leave a 10 cm (4 inch) (minimum) space from
the wall for proper ventilation.
10 cm
10 cm
2
Connect the power cord to a wall outlet.
CAUTION
Do not place the TV near or on sources
y y
of heat, as this may result in fire or other
damage.
Adjusting the angle of the TV to suit view
Swivel 20 degrees to the left or right and adjust
the angle of the TV to suit your view.
20
CAUTION
When adjusting the angle of the TV,
y y
watch out for your fingers.
- Personal injury may occur if hands or
fingers are pinched. If the product is
tilted too much, it may fall, causing
damage or injury.
(4 inc he s)
1 0 c m
10 cm
20
Securing the TV to a table
(For 42CM565)
Fix the TV to a table to prevent from tilting
forward, damage, and potential injury.
Mount the TV on a table, and then insert and
tighten the supplied screw on the rear of the
stand.
WARNING
To prevent TV from falling over, the TV
y y
should be securely attached to the floor/
wall per installation instructions. Tipping,
shaking, or rocking the TV may cause injury.

Tidying cables

1
Gather and bind the cables with the cable
management clip.
2
Fix the cable management clip firmly to the TV.
Cable management clip
CAUTION
Do not move the TV by holding the cable
y y
management clipr, as the cable holders may
break, and injuries and damage to the TV
may occur.