EINHELL EURO 403/50D Manual De Instrucciones página 9

Euro 403/50/100 D-Fiac
G Smoking is prohibited during
the spraying operation and in
the work room. Paint vapours
are highly flammable.
G Make sure there are no open
fires or open lights in the work
room. Sparking machines are
not to be used.
G Do not keep or consume food
and drink in the work room.
Paint vapours are harmful.
G The work room has to be
bigger than 30 m 3 and have
sufficient ventilation for
spraying and drying. Never
spray into the wind.
It is always imperative to
observe the regulations of your
local police authorities when
spraying combustible or
hazardous substances.
G Never process media such as
white petroleum spirit, butyl
alcohol and methylene chloride
with the PVC pressure hose
(reduced life span).
Operation of pressure
vessels in accordance
with the pertinent
pressure vessel
regulations
(e.g. Section 13 of the German
Pressure Vessel Act)
1. An operator of a pressure
vessel is required to keep the
pressure vessel in good
working order, to operate it
properly, to supervise its use,
to carry out essential
maintenance and repair work
immediately, and to introduce
essential safety measures
according to requirements.
2. The supervisory authorities
may order essential safeguards
from case to case.
3. A pressure vessel may not be
operated if it has any defects
which constitute a danger to
employees or third parties.
10.09.2002 12:09 Uhr
4. If pressure vessels of groups
III, IV, VI and VII suffer damage
to any pressure-bearing walls,
resulting in them being taken
out of operation in accordance
with Section 13 Paragraph 3 of
the German Pressure Vessel
Act, the operator has to notify
the supervisory authorities and
discuss what action is to be
taken.
Putting the compressor
into operation
Assembling the wheels and the
rubber buffers:
Fit the wheels as shown in Figure
1. Make sure that the valve is on
the outside!
Fit the supplied rubber buffers to
the support foot as shown in
Figure 2.
1
Oil plug:
Use a screwdriver to remove the
oil plug fromthe cylinder head (fig
2) and press the green oil plug
into the hole.
2
Seite 9
3
Connecting to the power
supply:
The compressor is delivered with
a mains cable and a CEE plug.
Important!
Before putting the compressor
into operation for the first time,
check that the direction of rotation
is correct. See the direction arrow
on the belt cover or on the fan
wheel.
The three-phase motor is
protected by an overload circuit-
breaker so that its winding will not
be damaged by phase failure,
overloading or short-circuiting.
The overload switch disconnects
when the nominal current is
exceeded.
After a brief cooling period you
can switch on again by turning the
ON/OFF switch at the compressor
pushbutton.
Long power supply cables, cable
extensions, cable reels etc. cause
the voltage drop and may prevent
the motor from starting up. At low
temperatures below 0°C there is
a risk of the motor not starting
due to stiffness.
I
GB
9