Hilti NCT IS 025-A22 Manual De Instrucciones Y Especificacion página 21

Ocultar thumbs Ver también para NCT IS 025-A22:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 43
5
Operation
5.1
Preparations at the workplace
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.2
Inserting the battery
CAUTION
Risk of injury! A falling battery presents a risk of injury.
▶ Take care to ensure that the battery is inserted correctly.
1. Push the battery into the product's battery holder until it engages with an audible click.
2. Check that the battery is seated securely.
5.3
Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out toward the rear.
5.4
Changing the cutting edges
1. Unscrew the cutting edge securing screws.
2. Ease the old cutting edges forward and out of the product.
3. Insert the new cutting edges into the product.
4. Tighten the cutting edge securing screws.
5.5
Assemble Hilti retaining leash (optional)
ATTENTION
Damage to the product and / or the retaining leash. Incorrect handling can result in damage to the
product and/or retaining leash.
▶ Do not use a metal chain as a retaining leash. Do not use retaining leashes longer than 6 ft (2 m).
To avoid damage and injury, when working at a height it is advisable to use the Hilti retaining strap.
The retaining strap allows a securing cord or leash to be attached.
When working with the product, you must comply with national regulations for working at heights.
1. Remove the battery.
2. Insert the two tabs on the retaining leash into the slots on each side of the base.
3. Secure the retaining leash with the screws supplied.
4. Refit the battery.
5.6
Dismantle the Hilti retaining leash (optional)
1. Remove the battery.
2. Remove the two retaining strap securing screws.
3. Pull the two retaining strap tabs out of the slots in the base and remove the retaining strap.
4. Refit the battery.
2207045
*2207045*
Printed: 14.06.2018 | Doc-Nr: PUB / 5436281 / 000 / 01
2
3
4
5
5
English
15

Publicidad

Tabla de contenido
loading

Tabla de contenido