Hilti NCT IS 025-A22 Manual De Instrucciones Y Especificacion página 22

5.7 Cutting 6
WARNING
Risk of injury! Risk of serious injury during the cutting operation.
▶ During the cutting operation great care must be taken to ensure that the hands and fingers are kept well
clear of the cutting head.
For cutting in tight spaces or where access is difficult, the cutting head can be rotated through 350°
about its longitudinal axis.
1. Rotate the cutting head to the desired working position.
2. Place the cable to be cut in the cutting head or, respectively, guide the cutting head into position around
the cable to be cut.
Always make sure that the cable to be cut is fully inserted into the cutting head.
Do not exceed the maximum cutting capacity.
Do not attempt to cut a cable that cannot be inserted fully into the cutting head.
3. Press the control switch.
4. Keep the control switch pressed until the cutting head begins to release the pressure. The is accompanied
by a clearly audible "pop".
◁ When the cut has been made, the product returns automatically to its initial position.
6 Care and maintenance of cordless tools
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt from the tool.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
Care of the Li­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the cordless tool if signs of damage are found or if parts malfunction. Have the tool
repaired by Hilti Service immediately.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
7 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
16 English
Printed: 14.06.2018 | Doc-Nr: PUB / 5436281 / 000 / 01
2207045
*2207045*