Replacing The Filters - Black and Decker HHVK320J Manual De Instrucciones

English
The state of charge indicator is an indication of approximate
levels of charge remaining in the battery pack according to
the following indicators:
The LED battery indicator displays the remaining charge
and warns you when the battery is low. The final LED will
flash continuously when there is only 1 minute of runtime
remaining. All LEDs will flash when the unit is discharged.
nOTE: The state of charge indicator is only an indication
of the charge left on the battery. It does not indicate tool
functionality and is subject to variation based on product
components, temperature and end-user application.
Fig. D
12
Extendable Crevice Tool
1. To extend the crevice tool
vacuum nozzle 3 until it clicks in place.
2. To collapse the crevice tool
nozzle 3 until it clicks in place.
Dry pick up
For everyday spills of dry material.
- Do not fill the dust bowl
filter.
Optimizing the suction force
In order to keep the suction force optimized, the filters must
be cleared regularly during use.
Emptying and cleaning the product.
Removing the dust bowl and filter (Fig. E, F)

WARNING:
should be cleaned regularly.
1. Hold the dust bowl over a trash can before pressing the
dust bowl release button
access door as shown in figure E.
11
2. While holding the dust bowl over a trash can, lightly
shake it to empty the dust bowl
3. Lift the prefilter out of the dust bowl
12
in figure F.
4. Lift the filter 13 out of the dust bowl
5. While holding the dust bowl over a trash can, empty the
dust bowl .
5
6. Install the filter 13 into the dust bowl
the prefilter 12 into the dust bowl
4
2
4 , pull it out from the
4 , push it into the vacuum
5 beyond the end of the
The filter is reusable and
to release the dust bowl
6
5 .
as shown
5
5 .
5 , then install
5 .
7. Close the dust bowl access door
into place.

WARNING:
without the filters. Optimum dust collection will only
be achieved with a clean filter.
Fig. E
11
Fig. F
13
5
Cleaning the dust bowl and filter
The prefilter 12 and filter
water. The dust bowl 5 can be wiped clean with a dry cloth.
1. Make sure the filter 13
dust bowl 5 are dry before installing.

Replacing the filters

The filters should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement filters are
available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
Remove the old filters as described in Cleaning
•
the Filters.
• Fit the new filters as described in Cleaning the Filters.
(cat. no: HHVKF10)
These fit all units. When these filters reach the end of their
lifespan they must be disposed of at a local recycling center.
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never
let any liquid get inside the vac; never immerse any part of
the vac into a liquid.

WARNING:
completely dry before using it.
11 until it clicks firmly
Never use the appliance
6
7
13 can be washed in warm soapy
, prefilter and the
12
Make sure the vacuum is