Cleaningand Maintenance; Safety Instructions - Casselin CFEV8 Manual De Instrucciones

WARNING !
During intensive use, the oil can heat up and ignite, remember to let the oil cool and change it
regularly to avoid this.
This fryer can tip over and cause injury if it is not fixed.
The device in operation can reach high temperatures. The exterior sides and the surface of the fryer
may be hot. The device must not be touched or moved during or immediately after use. Hands and
face must be protected from any splashes of grease.
At the end of use, set the temperature control knob to 0 ° C. Then unplug the device.
NOTE
The device is fitted with a safety system in the event of overheating. If tripped, unplug the device and allow it
to cool. If this protection system operates regularly, it is imperative to contact your dealer.
After automatic shutdown, the device can only be put into service by pressing the Reset button on the back
of the device, wait for the temperature to drop, press the Reset button.
6. CLEANING AND MAINTENANCE

6.1 Safety instructions

All maintenance, cleaning and repair of the appliance must be done with a disconnected appliance (isolated
from all electrical sources).
The use of caustic detergents and baking soda for cleaning is prohibited. Water must not get inside the
device.
Never immerse the device in water or other liquid.
Use Casselin brand products intended for this purpose.
WARNING
The device cannot be cleaned by direct water jet (no pressurized water jet).
6.2 Daily maintenance
Unplug the device
Clean the device with hot water and a clean cloth after each use
After cleaning, use a soft, dry cloth to polish and dry the device. All parts must be dried.
Store the device in a dry place.
6.3 Safety instructions for maintaining the device
Daily check for damage to the power cord. Never use the appliance when the cord is damaged. If the cord is
faulty, it must be replaced by a qualified technician.
In the event of a fault, contact your dealer.
Any maintenance or repair intervention must only be carried out by a professional.
NOTE
In the event of a fault, unplug the appliance, let it cool down and contact your dealer. If the device does not
start, check your power cord. The device should not be plugged into a multiple socket, but directly to a wall
outlet. For any other anomaly, contact your dealer.
NOTE
Waste from used devices: any used device must, when disposing of it, comply with the regulations in force
in its country *. It is essential to make the device unusable before disposal by removing the power supply
cable.
* in terms of ecology and recycling
EN