Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
Bottom of Unit
Use pliers or wrench to adjust the
leveling legs
Leveling Legs
Turn clockwise
to lower the unit
Fig.1.
NOTES:
• This appliance is intended for FREE-STANDING INSTALLATION ONLY, and is NOT intended to be built-in.
• Before connecting this appliance to electrical power supply, leave it to stand for approx. 24 hours, which will reduce
the possibility of malfunction in the cooling system due to transport handling.
• This appliance is approved for INDOOR USE ONLY and is NOT intended for outdoor operation.
Install this appliance in an area where the ambient temperature is
between 55°F (13°C) and 90°F (32°C). If the temperature around the
appliance is too low or high, cooling ability may be affected.
Remove exterior and interior packing, wipe the outside thoroughly with a
soft dry cloth and the inside with a wet, lukewarm cloth. Avoid placing the
unit in a narrow recess or near any heat source, direct sunlight, or mois-
ture. Let air circulate freely around the unit. Keep the rear of the refrigera-
tor 2 inches away from the wall.
LOCATION
1) Select a place with a strong, level floor.
2) Allow 2 inches of space between the refrigerator and any adjacent wall.
3) Avoid direct sunlight and heat. Direct sunlight may affect the acrylic
coating on the refrigerator exterior. Heat sources nearby will cause
higher electricity consumption.
Turn counter-
clockwise to
The refrigerating system in this refrigerator is a "Frost Free" system. This
raise the unit.
type of system requires no user intervention (i.e. defrosting) other than
selecting required cooling temperatures and the usual care and
maintenance.
To avoid vibration, the unit must be set level. This is accomplished by
adjusting the (2) front leveling legs, located under the refrigerator. (Fig 1)
IMPORTANT
3
Publicidad
Tabla de contenido
