Kicker RS65.2 Manual Del Propietário página 4

Fig. 1
Confi guring the RS
for Coaxial Operation
tweeter lead
wires
Fig. 2
tweeter output-level switch.
Higher switch settings mean
more volume from the tweeter.
INPUT jumper.
Install only for 2-way confi gurations;
do not install if bi-amping.
CROSSOVER CONFIGURATION
The KICKER RS crossover can be confi gured as a conventional 2-way crossover by installing the included
INPUT jumper into the - MID + -TW + input terminals as shown in Fig. 2. In this confi guration, the
amplifi ed signal from your source unit or amplifi er should be wired to the + and - terminals indicated on the
INPUT jumper.
The RS crossover can also be confi gured for bi-amp wiring by removing (or simply not installing) the
INPUT jumper. To use the bi-amp confi guration, you must connect two amplifi ed signals to each
crossover (you will need at least four amplifi er channels). Set the tweeter output-level switch to 0 dB, +3
dB, or +6 dB. Higher switch settings will result in more volume from the tweeter.
4
2009 RS Multilingual f01.indd 4 2009 RS Multilingual f01.indd 4
Step 1
coaxial mounting post
tweeter
Steps 3–6
RS crossover
RSCOMPONENTSYSTEM
boot
Steps 7–8
+ + +
6 3 0
OUTPUT INPUT
- + - + - + -
MID MID TW
-
+
INPUT
Step 2
OUTPUT
+
TW
11/21/2008 10:57:25 AM 11/21/2008 10:57:25 AM