Kicker RS65.2 Manual Del Propietário página 8

panel
Fig. 4
Flush Mounting the Tweeter
panel
Fig. 5
Angle Mounting the Tweeter
panel
Fig. 6
Surface Mounting the Tweeter
TWEETER MOUNTING
The tweeter can be mounted one of four ways: fl ush, angled, surface, and coaxial mounting. For fl ush
mounting applications, see Fig. 4. Choose a fl at location on the panel with space behind the panel to
allow room for the short mounting nut, motor structure, and tweeter. After checking the clearances, cut
a 1-3/4" (44mm) diameter mounting hole in the panel. Position the short mounting nut behind the panel.
Feed the wire through the optional fl ush ring, the hole in the panel, and the mounting nut. Mount the
tweeter by screwing the mounting nut onto the tweeter.
For angled mounting applications choose a fl at location on the panel with space behind the panel to allow
room for the long mounting nut, motor structure, tweeter post, and back angle ring. After checking the
clearances, cut a 1-3/4" (44mm) diameter mounting hole in the panel. Place the front angle ring in front
of the panel. Then place the wire and tweeter through the front angle ring and into the panel. Next, place
the wire through the back angle ring, place the back angle ring over the rear of the tweeter, and line-up
8
2009 RS Multilingual f01.indd 8 2009 RS Multilingual f01.indd 8
short
mounting nut
back angle ring
long
mounting nut
inset surface
surface mount
cup
RSCOMPONENTSYSTEM
tweeter
fl ush ring
front angle ring
rounded surface
tweeter
tweeter
11/21/2008 10:57:30 AM 11/21/2008 10:57:30 AM