Casselin CPAI350ET Manual De Instrucciones página 16

If the induction stove recognizes too large a difference in magnetic field, a drop in power occurs. This may
EN
cause the safety lock to operate, thus preventing the device from overheating. Therefore, avoid using
aluminum, bronze or non-metallic containers.
1. ON / OFF button
2. Heating / temperature / timer mode
3. Adjustment to decrease
4. Adjustment to increase
SETTING
Plug in the electrical outlet.
Place the saucepan in the center of the stove and press the button (item 1 for switching on). The indicator
light comes on when the power is on.
Press the button - pos 2 (heating power - left indicator light), the indicator lights up by default at 2000 W -
adjust the power using the up and down arrows to obtain a power of 100 to 3500 W .
Press button pos 3 (temperature) the indicator light comes on by default at 100 ° C then set the desired
temperature using the arrows.
Press the button pos 4 (timer) in order to set the cooking time using the selection arrows. The timer varies
from 0 to 180 mm.
You can stop the stove at any time by pressing the button (pos1). The appliance will stop heating. The fan
cools the stove for one minute and then turns off.
The induction stove will automatically turn off if there is no operation within 2 hours.
The temperature of accessible surfaces may be high when the appliance is in operation.
The device is not intended for permanent industrial use.
INDICATION
During operation, you can change the timer setting at any time using the selection keys and. Thanks to the
device's memory, the power or temperature level setting remains unchanged. The same method can be used
to change the power or temperature mode without changing the timer setting. The device will then operate
according to the parameters entered last.
NOTE
The device is fitted with a safety system in the event of overheating. If tripped, unplug the device and allow it
to cool. If this protection system operates regularly, it is imperative to contact our after-sales service or your
dealer.
After automatic shutdown, the device can only be put into service by pressing the Reset button on the back
of the device, wait for the oil temperature to drop, then unscrew the plastic protection by turning anti-
clockwise, press the reset button then screw the plastic protection back on.