Functions Settings - Kenwood KMM-BT356 Manual De Instrucciones

Functions Settings

1
Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select an item, then press the knob.
3
Repeat step 2 until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
• Refer to the INSTRUCTION MANUAL on the following website for the
detailed explanation of each item: <www.kenwood.com/cs/ce/>
• The availability of each item vary depending on the model.
[FUNCTION] menu items
[AUDIO CONTROL] : Sets your preferred audio settings.
[DISPLAY] : Sets your preferred control for the display window.
[TUNER SETTING] : Settings for radio source.
[USB] : Settings for using a USB device.
: Settings for using a Bluetooth device.
[BT MODE]
[REMOTE APP] : Settings for using smartphone to control this unit.
[MIC GAIN]* : Sets the sensitivity of the microphone.
: Adjusts the noise reduction level.
[NR LEVEL]*
[ECHO CANCEL]* : Adjusts the echo cancellation delay time.
: Settings for this unit.
[SYSTEM]
[CLOCK] : Adjusts the clock.
: Selects language for the menu and music information.
[ENGLISH]
[РУССКИЙ] : Selects language for the menu and music information.
[ESPANOL] : Selects language for the menu and music information.
: Selects language for the menu and music information.
[FRANCAIS]
[DEUTSCH] : Selects language for the menu and music information.
: Activates or deactivates the display demonstration.
[DEMO MODE]
* Applicable only while talking on the phone.
Examples of some well-used settings
1
2
.
3
4
5
6
7
Note:
For
mode before you can make the above settings.
Subwoofer Level Setting
Press the volume knob to enter [FUNCTION].
Turn the volume knob to select [AUDIO CONTROL], then press the knob.
Turn the volume knob to select [SUBWOOFER SET], then press the knob.
Turn the volume knob to select [SW SET ON], then press the knob.
Turn the volume knob to select [SUB-W LEVEL], then press the knob.
Turn the volume knob to adjust the subwoofer level, then press the
knob.
Press and hold to exit.
, you need to set [SWITCH PREOUT] to [SUB-W] in standby
7