Dyna-Glo IBF10PMDG-4 Manual De Instrucciones página 13

INSTALLATION
Fig. 11 - Operating Fan
Fan Rocker
Switch
LOCATING HEATER
This heater is designed to be mounted on a wall.
For convenience and efficiency, install heater:
1. Where there is easy access for operation,
inspection, and service.
2. In the coldest part of room.
3. A minimum of 3' away from furniture and draperies.
WALL MOUNTING
WARNING: Failure to position the parts in
accordance with these diagrams or failure to use only
parts specifically approved with this heater may result in
property damage or personal injury.
Mounting Bracket
The mounting bracket is located separately from the
unit, but packed inside the same box.
Fig. 12- Fan Wiring Diagram
Caution: Label all wires prior to
disconnection when servicing controls.
Wiring errors can cause improper and
dangerous operation.
If any of the original wire as supplied
with the appliance must be replaced, it
must be replaced with a wire of at least
a 60°C temperature rating.
Verify proper operation after servicing.
Use only 105C rated wires.
110/115
VAC
Black
12
Fan Switch
MAN AUTO
Thermo-switch
White
Green
Wiring Diagram
Fan