Removal Of Sanding Pad; Care And Maintenance - Kobalt SGY-AIR223 Manual Del Usuario

OPERATING INSTRUCTIONS
2. To adjust the speed of the sander, push
the air regulator (D) to the left gradually
to increase speed or push the air
regulator (D) to the right to decrease speed
(See Figure 2).

REMOVAL OF SANDING PAD

1. To remove the sanding pad, push in on
the spindle lock shaft and turn the
spindle lock (G) 1/4 inch clockwise. The
arrow on the knob will be pointing to the
word "UNLOCK". Unscrew the sanding
pad from the crank shaft (C) by spinning
the sanding pad counterclockwise
(See Figure 1).

CARE AND MAINTENANCE

ALWAYS DISCONNECT TOOL FROM THE AIR SUPPLY BEFORE
PERFORMING ANY MAINTENANCE ON THE TOOL.
Always make sure the tool is properly lubricated during operation. Proper
lubrication is shown in this instruction manual.
Clean the entire tool with a rag and lubricate the tool after each use. If storing
the tool for an extended period, run for approximately 30 seconds to
ensure oil has been evenly distributed throughout the tool. Always store tools
in a clean, dry environment away from the reach of children.
Recommended lubricants: air-tool oil or any other high grade turbine oil
containing moisture absorbent, rust inhibitors, metal wetting agents and an
EP (Extreme Pressure) additive. Consult your local retailer for further
assistance in selecting air tool oil best suited for proper lubrication.
2
1
B
C
13
D
-
+
UNLOCK
G